Caution / Notice / Hint
NOTE:
- If the No. 1 headlight ECU sub-assembly LH has been replaced, it is necessary to synchronize the vehicle information and initialize the No. 1 headlight ECU sub-assembly LH.*1
Refer to INITIALIZATION [10/2018 - 10/2020] Refer to INITIALIZATION [10/2020 - ]
- If the No. 1 headlight ECU sub-assembly LH has been replaced, it is necessary to initialize the No. 1 headlight ECU sub-assembly LH.*2
Refer to INITIALIZATION [10/2018 - 10/2020] Refer to INITIALIZATION [10/2020 - ]
- If any of the following are performed, it is necessary to initialize the No. 1 headlight ECU sub-assembly LH.
Refer to INITIALIZATION [10/2018 - 10/2020] Refer to INITIALIZATION [10/2020 - ]
- Replacement of the rear height control sensor sub-assembly LH
- Removal/installation of the rear height control sensor sub-assembly LH
- Work that changes the vehicle height such as replacement of suspension components
- When replacing the No. 1 headlight ECU sub-assembly LH, always replace it with a new one. If a No. 1 headlight ECU sub-assembly LH which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.
- *1: for Triple Beam Headlight
- *2: for Single Beam Headlight