DTC B1537-11: Telephone Sub Antenna Circuit Short to Ground; DTC B153713: Telephone Sub Antenna Circuit Open [10/2019 - 07/2022]: Procedure
- CHECK DTC
- Turn the ignition switch off.
- Connect the Techstream to the DLC3.
- Turn the ignition switch to ON and wait for 10 seconds or more.
- Turn the Techstream on.
- Clear the DTCs.
Body Electrical > Telematics > Clear DTCs
- Check for DTCs and check that no DTCs are output.
Body Electrical > Telematics > Trouble Codes
OK
No DTCs are output.
Result
Proceed to OK NG
Result:
OK
USE SIMULATION METHOD TO CHECK. Refer to HOW TO PROCEED WITH TROUBLESHOOTING [10/2018 - ]
Result:
NG
See step 2
- INSPECT TELEPHONE AND GPS ANTENNA (FOR FRONT SIDE)
- Disconnect the D telephone and GPS antenna cord (antenna cord sub-assembly) connector from the telephone and GPS antenna assembly (for Front Side).
*a Component without harness connected
(Telephone and GPS Antenna [for Front Side]) - Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition 4 - 4a Always 4 to 11 kΩ Result
Proceed to OK NG
Result:
NG
REPLACE TELEPHONE AND GPS ANTENNA (FOR FRONT SIDE). Refer to REMOVAL [10/2018 - 07/2022]
Result:
OK
See step 3
- Disconnect the D telephone and GPS antenna cord (antenna cord sub-assembly) connector from the telephone and GPS antenna assembly (for Front Side).
- INSPECT TELEPHONE AND GPS ANTENNA CORD (ANTENNA CORD SUB-ASSEMBLY)
- Disconnect the telephone and GPS antenna cord (antenna cord sub-assembly) connector from the telephone and GPS antenna assembly (for Front Side).
*a Component without harness connected
(to Telephone and GPS Antenna [for Front Side]) - Disconnect the telephone and GPS antenna cord (antenna cord sub-assembly) connector from the DCM (Telematics Transceiver).
*a Component without harness connected (Telephone and GPS Antenna Cord (Antenna Cord Sub-assembly)) - Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition D-4 - A-1 Always Below 1 Ω D-4 or A-1 - Body ground Always 10 kΩ or higher D-4a - A-1a Always Below 1 Ω D-4a or A-1a - Body ground Always 10 kΩ or higher Result
Proceed to OK NG
Result:
NG
REPLACE TELEPHONE AND GPS ANTENNA CORD (ANTENNA CORD SUB-ASSEMBLY). Refer to REMOVAL [10/2018 - 07/2022]
Result:
OK
See step 4
- Disconnect the telephone and GPS antenna cord (antenna cord sub-assembly) connector from the telephone and GPS antenna assembly (for Front Side).
- REPLACE DCM (TELEMATICS TRANSCEIVER)
- Replace the DCM (telematics transceiver) with a new one.
Refer to REMOVAL [10/2019 - 07/2022]
NOTE:- The ignition switch must be off.
- Do not exchange the DCM (telematics transceiver) with one from another vehicle.
Result
Proceed to NEXT
Result:
NEXT
PERFORM DCM ACTIVATION. Refer to DCM ACTIVATION [10/2019 - 07/2022]
- Replace the DCM (telematics transceiver) with a new one.