LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2021 >> UX 200 Base >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Collision/Avoidance >> Acoustic Vehicle Alerting System (Diagnostic Codes & Symptom Tests) >> Acoustic Vehicle Alerting System >> There is No Sound Made [07/2022 - ] >> Procedure

There is No Sound Made [07/2022 - ]: Procedure

  1. CHECK FOR DTC 
    1. Connect the Techstream to the DLC3.
    2. Turn the power switch on (IG).
    3. Turn the Techstream on.
    4. Enter the following menus: Body Electrical / Acoustic Vehicle Alerting System / Trouble Codes.

      Body Electrical > Acoustic Vehicle Alerting System > Trouble Codes 

    5. Check for DTCs.

      Result

      Result Proceed to
      DTC B1350 is not output A
      DTC B1350 is output B

    Result: 

    GO TO DTC CHART B1350. Refer to  DTC B1350: Speaker Circuit [07/2022 - ]  

    Result: 

    See step  2

  2. PERFORM ACTIVE TEST USING TECHSTREAM (Proximity Sound (Vehicle Stationary)) 
    1. Turn the power switch off.
    2. Connect the Techstream to the DLC3.
    3. Turn the power switch on (IG).
    4. Turn the Techstream on.
    5. Enter the following menus: Body Electrical / Acoustic Vehicle Alerting System / Active Test.
    6. Perform the Active Test according to the display on the Techstream.

      Body Electrical > Acoustic Vehicle Alerting System > Active Test 

      Tester Display Measurement Item Type Control Range
      Proximity Sound (Vehicle Stationary) 0 km/h (0 mph) vehicle proximity warning sound OFF or ON Produces warning sound when vehicle is stopped

      Body Electrical > Acoustic Vehicle Alerting System > Active Test 

      Tester Display
      Proximity Sound (Vehicle Stationary)

      Result

      Result Proceed to
      The warning sound is produced A
      The warning sound is not produced B

    Result: 

    REPLACE VEHICLE APPROACHING SPEAKER ASSEMBLY. Refer to  REMOVAL [07/2022 - ] 

    Result: 

    See step  3

  3. CHECK HARNESS AND CONNECTOR (VEHICLE APPROACHING SPEAKER CONTROLLER - VEHICLE APPROACHING SPEAKER ASSEMBLY) 
    1. Disconnect the F142 vehicle approaching speaker controller connector.
      GTY1124125Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Front view of wire harness connector
      (to Vehicle Approaching Speaker Controller)
    2. Measure the voltage according to the value(s) in the table below.

      Standard Voltage

      Tester Connection Switch Condition Specified Condition
      F142-1 (IG) - Body ground Power switch on (IG) 11 to 14 V
    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection Condition Specified Condition
      F142-6 (GND) - Body ground Always Below 1 Ω

      Result

      Proceed to
      OK
      NG

    Result: 

    OK 

    REPLACE VEHICLE APPROACHING SPEAKER ASSEMBLY. Refer to  REMOVAL [08/2021 - ] 

    Result: 

    NG 

    REPAIR OR REPLACE HARNESS OR CONNECTOR