Installation [10/2015 - 08/2016]: Procedure

1. Temporarily install the rear upper control arm assembly LH to the rear suspension member sub-assembly with the bolt and nut.
   NOTE:

   • Because the nut has its own stopper, do not turn the nut. Tighten the bolt with the nut secured.
   • Insert the bolt with the threaded end facing the rear of the vehicle.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

2. Position the rear upper control arm assembly LH as shown in the illustration.

   Standard Length (A)

   w/o AVS	9.9 mm (0.39 in.)
   w/ AVS	24.3 mm (0.957 in.)

3. Fully tighten the bolt.

   Torque: 120 N*m (1224 kgf*cm, 89 ft.*lbf) 

   NOTE:

   Because the nut has its own stopper, do not turn the nut. Tighten the bolt with the nut secured.

HINT: 

Perform the same procedure as for the LH side.

for 2WD: Refer to PROCEDURE - Step 11 [10/2015 - 08/2016]

for AWD: Refer to PROCEDURE - Step 12 [10/2015 - 08/2016]