Removal [08/2019 - ]: Procedure

PRECAUTION
NOTE:
After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Refer to PRECAUTION [08/2019 - ]
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Refer to INITIALIZATION [08/2019 - ]
REMOVE COOL AIR INTAKE DUCT SEAL
Refer to PROCEDURE - Step 1
REMOVE INLET AIR CLEANER ASSEMBLY
Refer to PROCEDURE - Step 2
REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE
Refer to PROCEDURE - Step 2
REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY
Refer to PROCEDURE - Step 22
REMOVE AIR CLEANER CASE SUB-ASSEMBLY
Refer to PROCEDURE - Step 23

DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY

Using a screwdriver, disengage the 4 claws and disconnect the transmission control cable assembly with clip from the No. 1 transmission control cable bracket.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Using a screwdriver, disengage the 2 claws and remove the clip from the transmission control cable assembly.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

REMOVE NO. 1 TRANSMISSION CONTROL CABLE BRACKET

Remove the 2 bolts and No. 1 transmission control cable bracket.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

REMOVE STARTER ASSEMBLY

Remove the terminal cap.

Remove the nut and disconnect terminal 30.
Disconnect the starter assembly connector.

Remove the 2 bolts and separate the wire harness.

Remove the 2 bolts and starter assembly.