LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2021 >> RC F Fuji Speedway Edition >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Gauges & Instrument Panels >> Meter / Gauge / Display - Service Information >> Trip Switch >> Inspection [10/2015 - ] >> Procedure

Inspection [10/2015 - ]: Procedure

  1. INSPECT TRIP SWITCH 
    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection Condition Specified Condition
      5 (RV) - 7 (E) Light control rheostat up switch pressed Below 1 Ω
      Light control rheostat up switch not pressed 10 kΩ or higher
      5 (RV) - 7 (E) Light control rheostat down switch pressed 1.71 to 1.89 kΩ
      Light control rheostat down switch not pressed 10 kΩ or higher
      4 (A/B) - 7 (E) ODO/TRIP switch pressed Below 1 Ω
      ODO/TRIP switch not pressed 10 kΩ or higher

      If the result is not as specified, replace the trip switch.

      GTY526120Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Component without harness connected
      (Trip Switch)
    2. GTY536380Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Component without harness connected
      (Trip Switch)

      Illumination Inspection

      1. Apply battery voltage to the trip switch and check that it illuminates.

        OK

        Condition Specified Condition
        Battery positive (+) → Terminal 3 (ILL+)
        Battery negative (-) → Terminal 8 (ILL-)        		 Illuminates

        If the result is not as specified, replace the trip switch.

scientia non olet · About LEMON Manuals