DTC B1537-11: Telephone Sub Antenna Circuit Short to Ground; DTC B1537-13: Telephone Sub Antenna Circuit Open [09/2020 - ]: Procedure
- CHECK DTC
- Turn the engine switch off.
- Connect the Techstream to the DLC3.
- Turn the engine switch on (IG) and wait for 10 seconds or more.
- Turn the Techstream on.
- Clear the DTCs.
Body Electrical > Telematics > Clear DTCs
- Check for DTCs and check that no DTCs are output.
Body Electrical > Telematics > Trouble Codes
OK
No DTCs are output.
Result
Proceed to OK NG
Result:
OK
USE SIMULATION METHOD TO CHECK. Refer to HOW TO PROCEED WITH TROUBLESHOOTING [09/2020 - 01/2023] , or refer to HOW TO PROCEED WITH TROUBLESHOOTING [01/2023 - ]
Result:
NG
See step 2
- INSPECT TELEPHONE AND GPS ANTENNA ASSEMBLY (for Front Side)
- Disconnect the telephone and GPS antenna assembly (for Front Side) connector.
*a Component without harness connected
(Telephone and GPS Antenna Assembly (for Front Side))Refer to REMOVAL [09/2020 - ]
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition 4 - 4a Always 9 to 11 kΩ Result
Proceed to OK NG
Result:
NG
REPLACE TELEPHONE AND GPS ANTENNA ASSEMBLY (for Front Side). Refer to REMOVAL [09/2020 - ]
Result:
OK
See step 3
- Disconnect the telephone and GPS antenna assembly (for Front Side) connector.
- INSPECT TELEPHONE AND GPS ANTENNA CORD (ANTENNA CORD SUB-ASSEMBLY)
- Disconnect the antenna connector from the telephone and GPS antenna assembly (for Front Side).
*a Component without harness connected
(to Telephone and GPS Antenna Assembly (for Front Side)) - Disconnect the antenna connector from the DCM (telematics transceiver).
*a Component without harness connected
(to DCM (Telematics Transceiver)) - Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition D-4 - A-1 Always Below 1 Ω D-4a - A-1a Always Below 1 Ω D-4 or A-1 - Body ground Always 10 kΩ or higher Result
Proceed to OK NG
Result:
NG
REPLACE TELEPHONE AND GPS ANTENNA CORD (ANTENNA CORD SUB-ASSEMBLY). Refer to REMOVAL [09/2020 - ]
Result:
OK
See step 4
- Disconnect the antenna connector from the telephone and GPS antenna assembly (for Front Side).
- REPLACE DCM (TELEMATICS TRANSCEIVER)
- Replace the DCM (telematics transceiver) with a new one.
Refer to REMOVAL [09/2020 - ]
NOTE:- The engine switch must be off.
- Do not exchange the DCM (telematics transceiver) with one from another vehicle.
Result
Proceed to NEXT
Result:
NEXT
PERFORM DCM ACTIVATION. Refer to DCM ACTIVATION [09/2020 - ]
- Replace the DCM (telematics transceiver) with a new one.