Caution / Notice / Hint

NOTE:

Before replacing the main body ECU (multiplex network body ECU), refer to Registration.
Refer to REGISTRATION [09/2014 - 10/2015] , or refer to REGISTRATION [10/2015 - 11/2017] , or refer to REGISTRATION [11/2017 - 11/2019]
When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.

HINT:

The automatic light control sensor sensitivity can be customized.
for Single Beam Headlight: Refer to CUSTOMIZE PARAMETERS [09/2014 - 11/2017] , or refer to CUSTOMIZE PARAMETERS [11/2017 - 10/2018]

for Triple Beam Headlight: Refer to CUSTOMIZE PARAMETERS [09/2014 - 11/2017] , or refer to CUSTOMIZE PARAMETERS [11/2017 - 10/2018]
Setting the meter illumination level to maximum brightness prevents the meter illumination from dimming when the headlight dimmer switch assembly is changed to the tail, head, or AUTO position at night. Therefore, check the meter illumination setting before proceeding to the following steps.