DTC B124B: Automatic High Beam System [09/2017 - 05/2019]: Procedure

1. Connect the Techstream to the DLC3.
2. Turn the power switch on (IG).
3. Turn the Techstream on.
4. Enter the following menus: System Select / Health Check.
5. Check for DTCs.

   Result

   Result	Proceed to
   Only DTC B124B is output	A
   DTC B124B is output at the same time	B

Result: 

B 

GO TO OTHER DTC CHART. Refer to  DIAGNOSTIC TROUBLE CODE CHART [09/2017 - 05/2019] 

Result: 

A 

See step  2

1. Check if a dynamic radar cruise control system, lane departure alert system (w/ Steering Control) and pre-collision system warning message are displayed on the combination meter assembly.

   Refer to DIAGNOSIS SYSTEM [09/2017 - 05/2019]

   OK

   No dynamic radar cruise control system, lane departure alert system (w/ Steering Control) and pre-collision system warning messages are displayed.

   Result

   Proceed to
   OK
   NG

Result: 

OK 

REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU). Refer to  REMOVAL [10/2014 - 05/2019] 

Result: 

NG 

GO TO FORWARD RECOGNITION CAMERA SYSTEM. Refer to  PROBLEM SYMPTOMS TABLE [09/2017 - 05/2019]