Hybrid System Indicator Malfunction [10/2014 - ]: Procedure

1. Check for DTCs.

   Refer to HOW TO PROCEED WITH TROUBLESHOOTING [10/2014 - 09/2017] , or refer to HOW TO PROCEED WITH TROUBLESHOOTING [09/2017 - 05/2019] , or refer to HOW TO PROCEED WITH TROUBLESHOOTING [05/2019 - ]

   OK

   No DTCs are output.

   Result

   Proceed to
   OK
   NG

Result: 

NG 

GO TO CAN COMMUNICATION SYSTEM. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [10/2014 - 09/2017]  , or refer to  HOW TO PROCEED WITH TROUBLESHOOTING [09/2017 - 05/2019]  , or refer to  HOW TO PROCEED WITH TROUBLESHOOTING [05/2019 - ] 

Result: 

OK 

See step  2

1. Using the Techstream, perform the Active Test.

   Refer to DATA LIST / ACTIVE TEST [10/2014 - ]

   Body Electrical > Combination Meter > Active Test 

   Tester Display	Measurement Item	Control Range	Diagnostic Note
   HV System Indicator	Hybrid system indicator	OFF, MIN, -50, 0, 100, 200, 300, 400, MAX	-

   Body Electrical > Combination Meter > Active Test 

   Tester Display
   HV System Indicator

   OK

   Hybrid system indicator indication is normal.

   Result

   Proceed to
   OK
   NG

Result: 

NG 

REPLACE COMBINATION METER ASSEMBLY. Refer to  REMOVAL [10/2014 - 09/2017]  , or refer to  REMOVAL [09/2017 - ] 

Result: 

OK 

See step  3

1. Using the Techstream, read the Data List.

   Refer to DATA LIST / ACTIVE TEST [10/2014 - ]

   Body Electrical > Combination Meter > Data List 

   Tester Display	Measurement Item	Range	Normal Condition	Diagnostic Note
   HV System Indicator	Hybrid system indicator value	Min.: -512%, Max.: 511%	-512 to 511%	-

   Body Electrical > Combination Meter > Data List 

   Tester Display
   HV System Indicator

   OK

   Hybrid system indicator value displayed on the Techstream is almost the same as hybrid system indicator indication.

   Result

   Proceed to
   OK
   NG

Result: 

NG 

GO TO HYBRID CONTROL SYSTEM. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [10/2014 - ] 

Result: 

OK 

See step  4

1. Replace the combination meter assembly.

   Refer to REMOVAL [10/2014 - 09/2017] , or refer to REMOVAL [09/2017 - ]

2. Check that the operation of the hybrid system indicator returns to normal.

   OK

   The operation of the hybrid system indicator returns to normal.

   Result

   Proceed to
   OK
   NG

Result: 

OK 

END (COMBINATION METER ASSEMBLY IS DEFECTIVE) 

Result: 

NG 

REPLACE HYBRID VEHICLE CONTROL ECU. Refer to  REMOVAL [10/2014 - 05/2019]  , or refer to  REMOVAL [05/2019 - ]