Caution / Notice / Hint
NOTE:
- After turning the power switch off, waiting time may be required before disconnecting the cable from the auxiliary negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary negative (-) battery terminal notices before proceeding with work.
Refer to PRECAUTION [09/2017 - 05/2019]
- When disconnecting the cable from the auxiliary negative (-) battery terminal while performing repairs, some systems need to be initialized after the cable is reconnected.
Refer to INITIALIZATION [09/2017 - 05/2019]
- When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.
- The following malfunctions may occur if a radio receiver assembly from another vehicle is installed to this vehicle. Therefore, when replacing the radio receiver assembly, be sure to replace it with new one.
- Communication malfunction DTC is output
- Does not operate normally
HINT:
- B1321 will not continue to output when clear DTC is performed even if the malfunction continues.
- Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed.
Refer to PRECAUTION [09/2017 - ]