Installation [09/2015 - ]: Procedure

INSTALL GENERATOR ASSEMBLY
1. Install the stud bolt to the cylinder block.
  Torque: 10 N*m (02 kgf*cm, 7 ft.*lbf)
2. Install the generator assembly with the 3 bolts and nut.
  Torque: 43 N*m (38 kgf*cm, 32 ft.*lbf)
3. Install the wire harness clamp bracket to the generator assembly with the bolt.
  Torque: 31 N*m (16 kgf*cm, 23 ft.*lbf)
4. Attach the clamp and connect the generator wire.
5. Connect the generator wire to terminal B with the nut.
  Torque: 12 N*m (22 kgf*cm, 9 ft.*lbf)
6. Install the terminal cap.
7. Connect the generator connector.
CONNECT OIL COOLER TUBE
Refer to PROCEDURE - Step 7
CONNECT VANE PUMP ASSEMBLY
Refer to PROCEDURE - Step 21
INSTALL AIR CLEANER ASSEMBLY
Refer to PROCEDURE - Step 37
INSTALL AIR CLEANER HOSE ASSEMBLY
Refer to PROCEDURE - Step 10
INSTALL FAN AND GENERATOR V BELT
Refer to PROCEDURE - Step 1
INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY
Refer to PROCEDURE - Step 19
INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH
Refer to PROCEDURE - Step 15
INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH
Refer to PROCEDURE - Step 16
INSTALL FRONT FENDER APRON TRIM PACKING A
Refer to PROCEDURE - Step 16
INSTALL V-BANK COVER SUB-ASSEMBLY
Refer to PROCEDURE - Step 69
INSTALL UPPER RADIATOR SUPPORT SEAL
Refer to PROCEDURE - Step 14
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Refer to INITIALIZATION [09/2015 - 08/2019] Refer to INITIALIZATION [08/2019 - ] ).