LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2021 >> LS 500h RWD >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Exterior Panels / Trim - Service Information (1 Of 4) >> FRONT BUMPER (except Sport Package) >> Removal [10/2017 - 09/2018] >> Procedure

Removal [10/2017 - 09/2018]: Procedure

  1. PRECAUTION 
    WARNING:

    Be sure to read precaution thoroughly before servicing.

    Refer to PRECAUTION [10/2017 - 10/2020]

    GTY824211Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    NOTE:

    After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

    Refer to PRECAUTION [10/2017 - 09/2019]

  2. REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 24

  3. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL 

    Refer to PROCEDURE - Step 3

    WARNING:
    • Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
    • If the airbag deploys for any reason, it may cause a serious accident.
    GTY581108Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    NOTE:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Refer to INITIALIZATION [10/2017 - 09/2018]

  4. REMOVE UPPER RADIATOR SUPPORT SEAL 

    Refer to PROCEDURE - Step 2

  5. REMOVE RADIATOR COVER PLATE 

    Refer to PROCEDURE - Step 3

  6. REMOVE LOWER RADIATOR AIR DEFLECTOR 

    Refer to PROCEDURE - Step 4

  7. REMOVE FRONT BUMPER ASSEMBLY 
    1. GTY806282Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Remove the 3 bolts.

    2. Remove the 4 clips.
      GTY806285Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      HINT: 

      Use the same procedure for the RH and LH side.

    3. Remove the screw.
      GTY780829Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *1 Front Bumper Seal Bracket

      HINT: 

      Use the same procedure for the RH and LH side.

    4. Remove the front bumper seal bracket.

      HINT: 

      Use the same procedure for the RH and LH side.

    5. GTY806283Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Remove the 8 screws.

    6. GTY806284Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Disconnect the 2 connectors.

    7. GTY819428Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Protective Tape

      Put protective tape around the front bumper assembly.

    8. Detach the claw and clip while pulling toward the outside of the vehicle and remove the front bumper assembly as shown in the illustration.
      GTY822040Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Place hands here
      Remove in this Direction (1)
      Remove in this Direction (2)

      HINT: 

      Use the same procedure for the RH and LH side.

    9. GTY794746Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Remove in this Direction

      Detach the claw and remove the front bumper assembly.

    10. w/ Headlight Cleaner System:
      1. Disconnect the headlight cleaner hose.

        HINT: 

        Prepare a container before performing the procedure.

scientia non olet · About LEMON Manuals