Caution / Notice / Hint
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the front bumper assembly removal/installation are shown below.
NECESSARY PROCEDURES AFTER PARTS REMOVED / INSTALLED / REPLACED
| Replaced Part or Performed Procedures | Necessary Procedures | Effect/Inoperative Function when Necessary Procedures are not Performed | Link |
|---|---|---|---|
| Disconnect cable from negative (-) auxiliary battery terminal | Memorize steering angle neutral point | Lane-keeping assist system (for Mono camera type) | for Mono Camera type: Refer to INITIALIZATION [10/2017 - 09/2018] for Stereo Camera type: Refer to INITIALIZATION [10/2017 - 10/2020] |
| Lane control system (for Stereo camera type) | |||
| Parking support brake system* | |||
| Pre-collision system (for Mono camera type) | |||
| Pre-collision system (for Stereo camera type) | |||
| AFS (Front-lighting adaptive system) | |||
Lighting system (EXT)
|
|||
| Variable gear ratio steering system | Refer to INITIALIZATION [10/2017 - 10/2020] | ||
| Parking assist monitor system | Refer to INITIALIZATION [10/2017 - 10/2020] | ||
| Panoramic view monitor system | Refer to INITIALIZATION [10/2017 - 10/2022] | ||
| Initialize rear door sunshade system | Rear door sunshade system | Refer to INITIALIZATION [10/2017 - ] | |
| Initialize power trunk lid system | Power trunk lid system | Refer to INITIALIZATION [10/2017 - 10/2020] | |
| Front bumper assembly (Including removal and installation) | Front television camera view adjustment | Panoramic view monitor system | Refer to CALIBRATION [10/2017 - 11/2021] |
|
Front television camera view adjustment | Panoramic view monitor system | Refer to CALIBRATION [10/2017 - 11/2021] |
*: When performing learning using the Techstream.
HINT:
- When the front bumper is damaged or deformed due to an accident or contact with other objects, etc., or the bumper installation area on the body is repaired, it is necessary to perform millimeter wave radar sensor adjustment.
Refer to ADJUSTMENT [10/2017 - 09/2018]
- If the bumper is damaged, there is a possibility that the installation area of the front side radar sensor may be deformed and the front side radar sensor system may not operate correctly, so visually inspect the front side radar sensor installation area (headlight, frame, bracket, stud bolt) to make sure it is not dented or bent.
Refer to ADJUSTMENT [10/2017 - 10/2020]
- If the visual inspection finds a problem, check the installation condition of the front side radar sensor, and adjust the installation position of the front side radar sensor as necessary.
- When the front bumper is damaged or deformed due to an accident or contact with other objects, etc., or the bumper installation area on the body is repaired, it is necessary to perform ultrasonic sensor detection angle measurement.
Refer to CALIBRATION [10/2017 - 10/2020]