Components [10/2020 - 11/2021]
Fig 1: Front Bumper (Except Sport Package) Replacement Components With Torque Specifications [10/2020 - 11/2021] (1 Of 7)
| Callout | Description | Callout | Description |
|---|---|---|---|
| *1 | LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY | *2 | NEGATIVE AUXILIARY BATTERY TERMINAL |
| Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping": N.m (kgf/cm, ft.lbf) | - | - |
| Callout | Description | Callout | Description |
|---|---|---|---|
| *A | w/o Advanced Drive | *B | w/ Advanced Drive |
| *1 | FRONT BUMPER ASSEMBLY | *2 | LOWER RADIATOR AIR DEFLECTOR |
| *3 | RADIATOR COVER PLATE | *4 | UPPER RADIATOR SUPPORT SEAL |
| *5 | FRONT BUMPER SEAL BRACKET | - | - |
| Callout | Description | Callout | Description |
|---|---|---|---|
| *A | w/ Headlight Cleaner System | *B | w/ Advanced Drive |
| *1 | FRONT LiDAR CLEANER COVER | *2 | FRONT LiDAR CLEANER NOZZLE |
| *3 | FRONT NO. 2 LiDAR CLEANER HOSE | *4 | HEADLIGHT CLEANER HOSE |
| *5 | HEADLIGHT WASHER ACTUATOR SUB-ASSEMBLY LH | *6 | HEADLIGHT WASHER ACTUATOR SUB-ASSEMBLY RH |
| *7 | HEADLIGHT WASHER COVER LH | *8 | HEADLIGHT WASHER COVER RH |
| *9 | NO. 2 WASHER BRACKET | *10 | WASHER BRACKET |
| *11 | CLAMP | *12 | SPRING NUT |
| • | Non-reusable part | - | - |
Fig 4: Front Bumper (Except Sport Package) Replacement Components With Torque Specifications [10/2020 - 11/2021] (4 Of 7)
| Callout | Description | Callout | Description |
|---|---|---|---|
| *A | w/ Advanced Park | *B | w/o Advanced Park |
| *C | w/ Advanced Drive | - | - |
| *1 | FRONT CENTER ULTRASONIC SENSOR | *2 | FRONT CORNER ULTRASONIC SENSOR |
| *3 | FRONT CORNER ULTRASONIC SENSOR RETAINER | *4 | FRONT LiDAR ADVANCED DRIVE SENSOR ASSEMBLY |
| *5 | FRONT NO. 2 ULTRASONIC SENSOR CLIP | *6 | FRONT SIDE ULTRASONIC SENSOR |
| *7 | FRONT SIDE ULTRASONIC SENSOR RETAINER | *8 | FRONT TELEVISION CAMERA ASSEMBLY |
| *9 | FRONT ULTRASONIC SENSOR CLIP | *10 | MILLIMETER WAVE RADAR SENSOR ASSEMBLY |
| *11 | NO. 2 ULTRASONIC SENSOR CLIP | *12 | NO. 4 ENGINE ROOM WIRE |
| *13 | NUT | - | - |
| N.m (kgf/cm, ft.lbf): Specified torque | • | Non-reusable part |
| Callout | Description | Callout | Description |
|---|---|---|---|
| *A | w/o Advanced Drive | *B | w/ Advanced Drive |
| *1 | FRONT BUMPER HOLE COVER RH | *2 | FRONT BUMPER NO. 1 ARM |
| *3 | FRONT BUMPER NO. 2 SIDE RETAINER LH | *4 | FRONT BUMPER NO. 2 SIDE RETAINER RH |
| *5 | FRONT BUMPER REINFORCEMENT EXTENSION LH | *6 | FRONT BUMPER REINFORCEMENT EXTENSION RH |
| *7 | FRONT BUMPER RETAINER | *8 | NO. 1 MOULDING TAPE |
| *9 | RADIATOR GRILLE ASSEMBLY | *10 | RADIATOR GRILLE BRACKET LH |
| *11 | RADIATOR GRILLE BRACKET RH | *12 | RADIATOR GRILLE PROTECTOR |
| *13 | RADIATOR GRILLE SIDE MOULDING LH | *14 | RADIATOR GRILLE SIDE MOULDING RH |
| *15 | UPPER RADIATOR GRILLE | - | - |
| • | Non-reusable part | - | - |
| Callout | Description | Callout | Description |
|---|---|---|---|
| *A | w/o Advanced Drive | *B | w/ Advanced Drive |
| *1 | FRONT BUMPER EXTENSION MOUNTING BRACKET | *2 | LOWER RADIATOR GRILLE MOULDING |
| *3 | NO. 2 RADIATOR GRILLE GARNISH | *4 | NO. 3 RADIATOR GRILLE GARNISH |
| *5 | NO. 4 RADIATOR GRILLE GARNISH | *6 | RADIATOR GRILLE (OR FRONT PANEL) EMBLEM |
| *7 | RADIATOR GRILLE MOULDING | *8 | RADIATOR GRILLE SEAL |
| *9 | UPPER RADIATOR SEAL | - | - |
| • | Non-reusable part | - | - |
Fig 7: Front Bumper (Except Sport Package) Replacement Components With Torque Specifications [10/2020 - 11/2021] (7 Of 7)
| Callout | Description | Callout | Description |
|---|---|---|---|
| *1 | FRONT BUMPER ENERGY ABSORBER SUB-ASSEMBLY | *2 | FRONT BUMPER NO. 2 ENERGY ABSORBER |
| *3 | FRONT BUMPER NO. 2 REINFORCEMENT SUB-ASSEMBLY | *4 | FRONT BUMPER REINFORCEMENT SUB-ASSEMBLY |
| *5 | FRONT BUMPER SIDE RETAINER LH | *6 | FRONT BUMPER SIDE RETAINER RH |
| *7 | LOWER ARM BRACKET BRACE SUB-ASSEMBLY LH | *8 | LOWER ARM BRACKET BRACE SUB-ASSEMBLY RH |
| N.m (kgf/cm, ft.lbf): Specified torque | - | - |