Inspection [10/2017 - ]: Procedure
- INSPECT LUGGAGE ELECTRICAL KEY SWITCH
- Check the resistance.
*a Component without harness connected
(Luggage Electrical Key Switch)- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Switch Condition Specified Condition L89-1(E) - L89-2 (UL) Switch on Below 1 Ω L89-1(E) - L89-2 (UL) Switch off 10 kΩ or higher HINT:
If the result is not as specified, replace the luggage electrical key switch.
- Measure the resistance according to the value(s) in the table below.
- Check the resistance.