Caution / Notice / Hint
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the kick door control sensor removal/installation are shown below.
| Replaced Part or Performed Procedures | Necessary Procedures | Effect/Inoperative Function When Necessary Procedures are not Performed | Link |
|---|---|---|---|
| Disconnect cable from negative (-) auxiliary battery terminal | Operate the multiplex network master switch assembly (retractable outer mirror switch) to extend and retract the outer rear view mirror assembly | Parking support brake system | Refer to INITIALIZATION [10/2022 - ] |
| Initialize rear door sunshade system | Rear door sunshade system | Refer to INITIALIZATION [10/2017 - ] | |
| Rear bumper assembly (Including removal and installation) | w/ Advanced Drive:
|
|
Refer to ADJUSTMENT [11/2021 - ] |
| Kick door control sensor | Reset connection history | There are cases where the connection history display differs from the vehicle condition | Refer to DATA LIST / ACTIVE TEST [10/2017 - 10/2023] , or refer to DATA LIST / ACTIVE TEST [10/2023 - ] |
HINT:
When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
- Learning completes when vehicle is driven
Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link Lane tracing assist system (for Stereo camera type) Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 seconds or more. for Stereo Camera type:
Refer to INITIALIZATION [10/2020 - ]
for Mono Camera type:
Refer to INITIALIZATION [10/2020 - 10/2023] , or refer to INITIALIZATION [10/2023 - ]Lane tracing assist system (for Mono camera type) Pre-collision system (for Stereo camera type) Pre-collision system (for Mono camera type) AFS (Front-lighting adaptive system) Lighting system (EXT) Cornering lights Advanced drive system Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 30 seconds or more.* Refer to INITIALIZATION [11/2021 - ] *: This can be completed by doing this for 30 seconds continuously or for a total of 30 seconds intermittently.
- Learning completes when vehicle is operated normally
Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link Power trunk lid system Fully close the luggage compartment door by hand.
HINT:
Initialization is not necessary if the above procedures are performed while the luggage compartment door is closed.Refer to INITIALIZATION [10/2020 - 10/2023] , or refer to INITIALIZATION [10/2023 - ]