LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2021 >> LS 500h RWD >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> (Door / Hatch) - Service Information (4 Of 4) >> Kick Sensor >> Removal [10/2020 - 11/2021] >> Caution / Notice / Hint

Caution / Notice / Hint

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the kick door control sensor removal/installation are shown below.

Replaced Part or Performed Procedures Necessary Procedures Effect/Inoperative Function When Necessary Procedures are not Performed Link
Disconnect cable from negative (-) auxiliary battery terminal Memorize steering angle neutral point Panoramic view monitor system w/ Advanced Park:
-
w/o Advanced Park:
Refer to INITIALIZATION [10/2017 - 10/2022]
Initialize rear door sunshade system Rear door sunshade system Refer to INITIALIZATION [10/2017 - ]
Rear bumper assembly (Including removal and installation) Adjust rear LiDAR advanced drive sensor assembly
  • Advanced drive system
  • Rear LiDAR system
-
Kick door control sensor Reset connection history There are cases where the connection history display differs from the vehicle condition Refer to DATA LIST / ACTIVE TEST [10/2017 - 10/2023]

HINT: 

When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.