LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2021 >> LS 500h RWD >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> (Door / Hatch) - Service Information (4 Of 4) >> Fuel Lid Opener Switch >> Inspection [10/2017 - ] >> Procedure

Inspection [10/2017 - ]: Procedure

  1. INSPECT TRUNK AND FUEL SWITCH ASSEMBLY 
    1. Check the resistance.
      GTY825604Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Component without harness connected
      (Trunk and Fuel Switch Assembly)
      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance

        Tester Connection Switch Condition Specified Condition
        G73-2 (B) - G73-3 (L) Switch on Below 1 Ω
        G73-2 (B) - G73-3 (L) Switch off 10 kΩ or higher

        HINT: 

        If the result is not as specified, replace the trunk and fuel switch assembly.

    2. Inspect the illumination operation.
      1. Apply auxiliary battery voltage to the trunk and fuel switch assembly connector, and check that the trunk and fuel switch assembly LED illuminates.

        OK

        Tester Connection Specified Condition
        G73-1 (ILL+) - Auxiliary battery positive (+)
        G73-5 (ILL-) - Auxiliary battery negative (-)        		 LED illuminates

        HINT: 

        If the result is not as specified, replace the trunk and fuel switch assembly.

scientia non olet · About LEMON Manuals