LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2021 >> LS 500h AWD >> Repair and Diagnosis >> Transmission >> Transmission Control Systems >> Hybrid Transaxle System (L310F) - Service Information (3 Of 3) >> Shift Lever >> Removal [10/2023 - ] >> Procedure

Removal [10/2023 - ]: Procedure

  1. REMOVE CONSOLE BOX ASSEMBLY 

    Refer to REMOVAL [10/2023 - ]

  2. REMOVE NO. 1 CONSOLE BOX DUCT 
    1. Remove the 2 clips and No. 1 console box duct.
      GTY777726Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. REMOVE SHIFT POSITION INDICATOR 

    HINT: 

    Perform this procedure only when replacing the shift position indicator.

    1. Remove the 2 screws, 2 claws and shift position indicator from the console upper panel assembly.
      GTY799676Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  4. REMOVE TRANSMISSION FLOOR SHIFT ASSEMBLY 
    NOTE:

    w/o Front LiDAR Sensor:

    When disconnecting a wire harness of any component connected to the supply power of the integrated capacitor (integration control supply) or when removing the integrated capacitor (integration control supply), make sure to wait 5 minutes or more after turning the ignition switch off for self-diagnosis to complete and the voltage of the integrated capacitor (integration control supply) to discharge.

    1. GTY832639Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Disconnect the 2 clamps.

    2. Disconnect the transmission floor shift assembly connector.
      GTY799314Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Remove the 4 bolts and transmission floor shift assembly from the body.
      GTY799690Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals