Operating Light Control Rheostat does not Change Light Brightness [10/2017 - 10/2020]: Procedure

1. Using the Techstream, read the Data List.

   Refer to DATA LIST / ACTIVE TEST [10/2017 - 10/2020]

   Body Electrical > Combination Meter > Data List 

   Tester Display	Measurement Item	Range	Normal Condition	Diagnostic Note
   Light Control Up Switch	Light control rheostat up switch	OFF or ON	OFF: Switch released ON: Switch pressed	-
   Light Control Down Switch	Light control rheostat down switch	OFF or ON	OFF: Switch released ON: Switch pressed	-

   Body Electrical > Combination Meter > Data List 

   Tester Display
   Light Control Up Switch
   Light Control Down Switch

   OK

   Light control rheostat up or down switch condition displayed on the Techstream changes with the actual switch operation.

   Result

   Proceed to
   OK
   NG

Result: 

OK 

REPLACE COMBINATION METER ASSEMBLY. Refer to  REMOVAL [10/2017 - 10/2020] 

Result: 

NG 

See step  2

1. Disconnect the G34 combination meter assembly connector.
2. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   G34-25 (TR) - G8-5 (RV)	Always	Below 1 Ω
   G34-26 (SW3) - G8-7 (E)	Always	Below 1 Ω
   G34-25 (TR) or G8-5 (RV) - Other terminals and body ground	Always	10 kΩ or higher
   G34-26 (SW3) or G8-7 (E) - Other terminals and body ground	Always	10 kΩ or higher

   Result

   Proceed to
   OK
   NG

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR 

Result: 

OK 

See step  3

1. Temporarily replace the trip switch with a new or normally functioning one.

   Refer to REMOVAL [10/2017 - 10/2023]

   Result

   Proceed to
   OK
   NG

Result: 

OK 

REPLACE COMBINATION METER ASSEMBLY. Refer to  REMOVAL [10/2017 - 10/2020] 

Result: 

NG 

REPLACE TRIP SWITCH. Refer to  REMOVAL [10/2017 - 10/2023]