Entire Combination Meter does not Operate [10/2023 - ]: Procedure

1. *1: w/ Front LiDAR Sensor
2. *2: w/o Front LiDAR Sensor

1. Disconnect the G162*1 or G209*2 combination meter assembly connector.
2. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   W/ FRONT LIDAR SENSOR
   
   

   Tester Connection	Condition	Specified Condition
   G162-2 (ES) - Body ground	Always	Below 1 Ω

   W/O FRONT LIDAR SENSOR
   
   

   Tester Connection	Condition	Specified Condition
   G209-2 (ES) - Body ground	Always	Below 1 Ω

3. Measure the voltage according to the value(s) in the table below.

   Standard Voltage

   W/ FRONT LIDAR SENSOR
   
   

   Tester Connection	Switch Condition	Specified Condition
   G162-6 (IG+) - Body ground	Power switch off	Below 1 V
   	Power switch on (IG)	11 to 14 V
   G162-5 (B) - Body ground	Power switch off	11 to 14 V

   W/O FRONT LIDAR SENSOR
   
   

   Tester Connection	Switch Condition	Specified Condition
   G209-6 (IG+) - Body ground	Power switch off	Below 1 V
   	Power switch on (IG)	11 to 14 V
   G209-5 (B) - Body ground	Power switch off	11 to 14 V

   Result

   Proceed to
   OK
   NG

Result: 

OK 

REPLACE COMBINATION METER ASSEMBLY. Refer to  REMOVAL [10/2023 - ] 

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR