DTC B1511-87: Lost Communication with Meter Gigabit Video Interface Missing Message [10/2023 - ]: Procedure

1. Disconnect the G178 meter mirror sub-assembly connector.
2. Disconnect the G179 combination meter assembly connector.
3. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   G178-1 (HGV-) - G179-2 (MGV-)	Always	Below 1 Ω
   G178-2 (HGV+) - G179-1 (MGV+)	Always	Below 1 Ω
   G178-3 (HGVG) - G179-3 (MGVG)	Always	Below 1 Ω
   G178-1 (HGV-) or G179-2 (MGV-) - Body ground	Always	10 kΩ or higher
   G178-2 (HGV+) or G179-1 (MGV+) - Body ground	Always	10 kΩ or higher

   Result

   Proceed to
   OK
   NG

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR 

Result: 

OK 

See step  2

1. Replace the meter mirror sub-assembly with a new or known good one.

   HINT: 

   Refer to REMOVAL [10/2023 - ]

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  3

1. Clear the DTCs.

   Body Electrical > Combination Meter > Clear DTCs 

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  4

1. Check for DTCs.

   Body Electrical > Combination Meter > Trouble Codes 

   Result

   Result	Proceed to
   B1510-87 is not output	A
   B1510-87 is output	B

Result: 

A 

END (METER MIRROR SUB-ASSEMBLY IS DEFECTIVE) 

Result: 

B 

REPLACE COMBINATION METER ASSEMBLY. Refer to  REMOVAL [10/2023 - ]