| C1466 |
Rear Speed Sensor RH Circuit |
-
277
278
279
280
281
288
308 |
- INF Code: -
- When speed sensor is normal (no shorts or opens in sensor circuit and supply power is normal), speed sensor supply power is on, and skid control ECU assembly supply power is not low, speed sensor power supply is invalid for 60 seconds or more consecutively.
- INF Code: 277
- At a vehicle speed of 10 km/h (6 mph) or more, an open or short signal occurs in the speed sensor circuit.
- INF Code: 278
- A malfunction occurs in 2 or more wheels.
- INF Code: 279
- An open is detected in the speed sensor signal circuit for 0.5 seconds or more.
- INF Code: 280
- Instantaneous interruption of sensor signal from the malfunctioning wheel occurs 255 times or more.
- INF Code: 281
- Frequency of 2.4 kHz or more is input.
- INF Code: 288
- Either of the following is detected:
- When IG1 voltage is 9.5 V or more, sensor supply voltage drops for 0.5 seconds or more.
- When IG1 voltage is 9.5 V or more, sensor supply voltage fluctuates for 60 seconds or more.
- INF Code: 308
- At a vehicle speed below 200 km/h (124 mph), the speed sensor generates pulses of under 300 μs at 6 ms intervals.
|
- INF Code: -
- Open or short in wire harness
- Rear speed sensor RH
- Skid control ECU assembly
- INF Code: 277, 278, 279, 280
- Open or short in speed sensor
- Improperly installed speed sensor, or abnormal clearance between sensor and rotor
- Open or short in wire harness
- Improperly connected connector, deformation or corrosion of terminals
- Resistance in speed sensor circuit
- Rear speed sensor RH
- Skid control ECU assembly
- INF Code: 281
- Open or short in speed sensor
- Open or short in wire harness
- Rear speed sensor RH
- Rear speed sensor rotor RH (Rear axle hub and bearing assembly RH)
- INF Code: 288
- Open or short in wire harness
- Skid control ECU assembly
- INF Code: 308
- Foreign matter attached to speed sensor
- Speed sensor rotor malfunction (foreign matter attached)
- Rear speed sensor RH
|
Comes on
(When only SAE code C0513 (Case 1, 2 and 3), C0514, C0515, C0516 (Case 2), C140E or C14EA (Case 1 and 2) is stored) |
- INF Code -: SAE Code C14EA (Case 2)
- INF Code 277: SAE Code C0513 (Case 1 and 2)
- INF Code 278: SAE Code C140E
- INF Code 279: SAE Code C0514 and C0515
- INF Code 280: SAE Code C0516 (Case 2)
- INF Code 288: SAE Code C14EA (Case 1)
- INF Code 308: SAE Code C0513 (Case 3)
|
| C1467 |
Rear Speed Sensor LH Circuit |
-
290
291
292
293
294
301
309 |
- INF Code: -
- When speed sensor is normal (no shorts or opens in sensor circuit and supply power is normal), speed sensor supply power is on, and skid control ECU assembly supply power is not low, speed sensor power supply is invalid for 60 seconds or more consecutively.
- INF Code: 290
- At a vehicle speed of 10 km/h (6 mph) or more, an open or short signal occurs in the speed sensor circuit.
- INF Code: 291
- A malfunction occurs in 2 or more wheels.
- INF Code: 292
- An open is detected in the speed sensor signal circuit for 0.5 seconds or more.
- INF Code: 293
- Instantaneous interruption of sensor signal from the malfunctioning wheel occurs 255 times or more.
- INF Code: 294
- Frequency of 2.4 kHz or more is input.
- INF Code: 301
- Either of the following is detected:
- When IG1 voltage is 9.5 V or more, sensor supply voltage drops for 0.5 seconds or more.
- When IG1 voltage is 9.5 V or more, sensor supply voltage fluctuates for 60 seconds or more.
- INF Code: 309
- At a vehicle speed below 200 km/h (124 mph), the speed sensor generates pulses of under 300 μs at 6 ms intervals.
|
- INF Code: -
- Open or short in wire harness
- Rear speed sensor LH
- Skid control ECU assembly
- INF Code: 290, 291, 292, 293
- Open or short in speed sensor
- Improperly installed speed sensor, or abnormal clearance between sensor and rotor
- Open or short in wire harness
- Improperly connected connector, deformation or corrosion of terminals
- Resistance in speed sensor circuit
- Rear speed sensor LH
- Skid control ECU assembly
- INF Code: 294
- Open or short in speed sensor
- Open or short in wire harness
- Rear speed sensor LH
- Rear speed sensor rotor LH (Rear axle hub and bearing assembly LH)
- INF Code: 301
- Open or short in wire harness
- Skid control ECU assembly
- INF Code: 309
- Foreign matter attached to speed sensor
- Speed sensor rotor malfunction (foreign matter attached)
- Rear speed sensor LH
|
Comes on
(When only SAE code C050D (Case 1, 2 and 3), C050E, C050F, C0510, C140D or C14E7 (Case 1 and 2) is stored) |
- INF Code -: SAE Code C14E7 (Case 2)
- INF Code 290: SAE Code C050D (Case 1 and 2)
- INF Code 291: SAE Code C140D
- INF Code 292: SAE Code C050E and C050F
- INF Code 293: SAE Code C0510 (Case 2)
- INF Code 301: SAE Code C14E7 (Case 1)
- INF Code 309: SAE Code C050D (Case 3)
|