Installation [10/2017 - ]: Procedure

INSTALL REAR LIGHT ASSEMBLY LH

Set the rear light assembly LH into place.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Install in this Direction

Install the 2 nuts and 2 cap nuts.

Torque: 4.5 N.m (46 kgf/cm, 40 in.lbf)

*a	Nut
*b	Cap Nut

INSTALL LUGGAGE COMPARTMENT DOOR COVER
Refer to PROCEDURE - Step 29 [10/2017 - 10/2020] , or refer to PROCEDURE - Step 32 [10/2020 - 11/2021] , or refer to PROCEDURE - Step 32 [11/2021 - 10/2023] , or refer to PROCEDURE - Step 32 [10/2023 - ]
INSTALL NO. 2 LUGGAGE COMPARTMENT LIGHT ASSEMBLY
Refer to PROCEDURE - Step 2
INSTALL SWITCH BEZEL
Refer to PROCEDURE - Step 31 [10/2017 - 10/2020] , or refer to PROCEDURE - Step 34 [10/2020 - 11/2021] , or refer to PROCEDURE - Step 34 [11/2021 - 10/2023] , or refer to PROCEDURE - Step 34 [10/2023 - ]
INSTALL LUGGAGE COMPARTMENT DOOR ASSIST GRIP
Refer to PROCEDURE - Step 32 [10/2017 - 10/2020] , or refer to PROCEDURE - Step 35 [10/2020 - 11/2021] , or refer to PROCEDURE - Step 35 [11/2021 - 10/2023] , or refer to PROCEDURE - Step 35 [10/2023 - ]