Customize Parameters [10/2017 - 10/2020]

CUSTOMIZE METER / GAUGE SYSTEM

Customizing with the Techstream.

Connect the Techstream to the DLC3.
Turn the power switch on (IG).
Turn the Techstream on.
Enter the following menus: Customize Setting / Warning or Display.

Select the setting by referring to the table below.

NOTE:

Be sure to record the current value before customizing.

Warning

Tester Display	Description	Default	Setting	ECU
Lane Change Flashing Times Adjust	Function to change the lane change flashing time	3	$00:OFF, $01:3, $02:4, $03:5, $04:6, $05:7	Combination meter assembly
Flasher Sound Volume Adjust	Function to change the flasher sound volume	Medium	$02:Large, $00:Medium, $01:Small	Combination meter assembly
Reverse Buzzer Setting	Function to change the reverse warning buzzer type	Continual	$00:Continual, $01:Single	Combination meter assembly

Display

Tester Display	Description	Default	Setting	ECU
ODO Display Time After IG OFF Adjust	Function to change the ODO display time after the power switch is turned off	30s	$00:30s, $01:60s, $02:600s, $03:OFF	Combination meter assembly
ECO Drive Indicator Zone Display Function (Meter)	Function to change the ECO drive indicator zone display	ON	$00:OFF, $01:ON	Combination meter assembly