Removal [10/2020 - 10/2022]: Procedure
- PRECAUTION WARNING:
- Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.
Refer to PRECAUTION [10/2020 - 11/2021] , or refer to PRECAUTION [11/2021 - 10/2023]
- Wear protective gloves. Sharp areas on the parts may injure your hands.
- There is risk of injury.
NOTE:After the ignition switch is turned off, there may be a waiting time before disconnecting the negative (-) battery terminal.
Refer to PRECAUTION [10/2020 - 10/2023]
- Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.
- REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY
Refer to PROCEDURE - Step 25
- DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
- Disconnect the cable from the negative (-) battery terminal.
Refer to REMOVAL [10/2020 - 10/2022]
- Disconnect the cable from the negative (-) battery terminal.
- REMOVE REAR SEAT CUSHION ASSEMBLY LH
Refer to PROCEDURE - Step 4
- REMOVE REAR SEAT CUSHION ASSEMBLY RH
HINT:
Use the same procedure described for the LH side.
- REMOVE REAR SEAT CUSHION LOCK HOOK
Refer to PROCEDURE - Step 7
- REMOVE REAR CENTER SEAT LAP TYPE BELT ASSEMBLY RH
- REMOVE REAR SEATBACK ASSEMBLY LH
Refer to PROCEDURE - Step 8
- REMOVE REAR SEATBACK ASSEMBLY RH
Refer to PROCEDURE - Step 9
- REMOVE REAR NO. 2 SEAT ADJUSTER ASSEMBLY
Refer to PROCEDURE - Step 11
- REMOVE REAR NO. 1 SEAT ADJUSTER ASSEMBLY
Refer to PROCEDURE - Step 12
- REMOVE REAR SEAT INNER BELT ASSEMBLY LH
- REMOVE REAR SEAT INNER BELT ASSEMBLY RH