DTC C0063-28: Yaw Rate Sensor Signal Bias Level Out of Range / Zero Adjustment Failure; DTC C0063-96: Yaw Rate Sensor Component Internal Failure [09/2018 - 10/2023]: Procedure

1. Replace the acceleration sensor (yaw rate sensor).

   Refer to REMOVAL [09/2018 - 10/2020] , or refer to REMOVAL [10/2020 - 11/2021] , or refer to REMOVAL [11/2021 - 10/2023]

   NOTE:

   Check the acceleration sensor (yaw rate sensor) signal after replacement.

   Refer to TEST MODE PROCEDURE [09/2018 - 10/2023]

   Result

   Proceed to
   NEXT

Result: 

NEXT 

END