Removal [12/2017 - ]: Procedure
- REMOVE SPOT LIGHT ASSEMBLY (for Sliding Roof)
- REMOVE SPOT LIGHT ASSEMBLY LH (for Panoramic Moon Roof)
- Insert moulding remover B at the location shown in the illustration and pull the spot light assembly LH slightly forward.NOTE:
Do not pull moulding remover B too much as the claws of the spot light assembly are attached.
- Detach the claw and remove the spot light assembly LH.
- Disconnect the connector.
- Insert moulding remover B at the location shown in the illustration and pull the spot light assembly LH slightly forward.
- REMOVE SPOT LIGHT ASSEMBLY RH (for Panoramic Moon Roof)
HINT:
Use the same procedure described for the LH side.