Removal [10/2020 - 10/2022]: Procedure
- REMOVE INSTRUMENT SIDE PANEL LH
Refer to PROCEDURE - Step 3
- REMOVE INSTRUMENT SIDE PANEL RH
Refer to PROCEDURE - Step 4
- REMOVE LOWER NO. 1 INSTRUMENT PANEL PAD SUB-ASSEMBLY
Refer to PROCEDURE - Step 14
- REMOVE LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY
Refer to PROCEDURE - Step 22
- REMOVE NO. 1 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY
Refer to PROCEDURE - Step 16
- REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY
Refer to PROCEDURE - Step 20
- REMOVE INSTRUMENT PANEL SAFETY PAD INSERT SUB-ASSEMBLY
Refer to PROCEDURE - Step 21
- REMOVE INSTRUMENT CLUSTER FINISH PANEL GARNISH ASSEMBLY
Refer to PROCEDURE - Step 24
- REMOVE MULTI-DISPLAY ASSEMBLY
- Remove the 2 bolts.
- Place your hands shown in the illustration and move it toward the rear of the vehicle to detach the clip.
Place Hands Here Remove in this Direction NOTE:If excessive force is applied to the multi-display assembly, it may become damaged.
- Detach the clamp, disconnect each connector and remove the multi-display assembly.
*A w/ Panoramic View Monitor System
- Remove the 2 bolts.
- REMOVE MULTI-DISPLAY CONTROLLER BRACKET A