Caution / Notice / Hint

NOTE:

Inspect the fuses for circuits related to this system before performing the following procedure.
Before replacing the main body ECU (multiplex network body ECU), refer to Registration.
Refer to REGISTRATION [10/2023 - ]
If the headlight ECU sub-assembly LH has been replaced, it is necessary to synchronize the vehicle information and initialize the headlight ECU sub-assembly LH.
Refer to REGISTRATION [10/2023 - ]
When replacing the headlight ECU sub-assembly LH, always replace it with a new one. If a headlight ECU sub-assembly LH which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.
After the ignition switch is turned off, there may be a waiting time before disconnecting the negative (-) battery terminal.
Refer to BEFORE DISCONNECTING BATTERY [10/2023 - ]
When disconnecting and reconnecting the battery.
HINT:

When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.

Refer to AUTOMATIC LEARNING CHART [10/2023 - ]