DTC B15CB-11: Telephone Main Antenna Circuit Short to Ground; DTC B15CB-13: Telephone Main Antenna Circuit Open [10/2022 - ]: Procedure
- CLEAR DTC
Pre-procedure1
- Turn the ignition switch to ON and wait for 10 seconds.
Procedure1
- Clear the DTCs.
Body Electrical > Telematics > Clear DTCs
Result
Proceed to NEXT Post-procedure1
- None
Result:
NEXT
See step 2
- Turn the ignition switch to ON and wait for 10 seconds.
- CHECK FOR DTC
- Check for DTCs.
Body Electrical > Telematics > Trouble Codes
Result
Result Proceed to DTCs are not output A DTCs are output B
Result:
A
USE SIMULATION METHOD TO CHECK. Refer to HOW TO PROCEED WITH TROUBLESHOOTING [10/2022 - 10/2023] , or refer to HOW TO PROCEED WITH TROUBLESHOOTING [10/2023 - ]
Result:
B
See step 3
- Check for DTCs.
- INSPECT TELEPHONE AND GPS ANTENNA (for Roof Side)
Pre-procedure1
- Remove the telephone and GPS antenna (for Roof Side).
Refer to REMOVAL [10/2022 - 10/2023] , or refer to REMOVAL [10/2023 - ]
Procedure1
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition 4 - 4a Always 4 to 11 kΩ Result
Proceed to OK NG Post-procedure1
- None
Result:
NG
REPLACE TELEPHONE AND GPS ANTENNA (for Roof Side). Refer to REMOVAL [10/2022 - 10/2023] , or refer to REMOVAL [10/2023 - ]
Result:
OK
See step 4
- Remove the telephone and GPS antenna (for Roof Side).
- INSPECT TELEPHONE AND GPS ANTENNA CORD (ANTENNA CORD SUB-ASSEMBLY [FLOOR])
Pre-procedure1
- Disconnect the antenna connector from the telephone and GPS antenna (for Roof Side).
*a Front view of wire harness connector
(to Telephone and GPS Antenna [for Roof Side])*b Front view of wire harness connector
(to Wire Harness) - Disconnect the antenna connector from the wire harness.
Procedure1
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition A-4 - G153-[1] (ANT1) Always Below 1 Ω A-4a - G153-[1a] Always Below 1 Ω A-4 - Body ground Always 10 kΩ or higher Result
Proceed to OK NG Post-procedure1
- None
Result:
NG
REPLACE TELEPHONE AND GPS ANTENNA CORD (ANTENNA CORD SUB-ASSEMBLY [FLOOR]). Refer to REMOVAL [10/2022 - 10/2023] , or refer to REMOVAL [10/2023 - ]
Result:
OK
See step 5
- Disconnect the antenna connector from the telephone and GPS antenna (for Roof Side).
- CHECK HARNESS AND CONNECTOR (ANTENNA CORD SUB-ASSEMBLY [FLOOR] - DCM [TELEMATICS TRANSCEIVER])
Pre-procedure1
- Disconnect the antenna connector from the antenna cord sub-assembly (floor).
*a Front view of wire harness connector
(to Antenna Cord Sub-assembly [Floor])*b Front view of wire harness connector
(to DCM [Telematics Transceiver]) - Disconnect the antenna connector from the DCM (telematics transceiver).
Procedure1
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition G153-1 (ANT1) - G175-1 (ANT1) Always Below 1 Ω G153-[1a] - G175-[1a] Always Below 1 Ω G153-1 (ANT1) - Body ground Always 10 kΩ or higher Result
Proceed to OK NG Post-procedure1
- None
Result:
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
Result:
OK
See step 6
- Disconnect the antenna connector from the antenna cord sub-assembly (floor).
- CHECK TELEPHONE AND GPS ANTENNA (for Roof Side)
Pre-procedure1
- Replace the telephone and GPS antenna (for Roof Side) with a known good one.
Refer to REMOVAL [10/2022 - 10/2023] , or refer to REMOVAL [10/2023 - ]
Procedure1
- Clear the DTCs.
Body Electrical > Telematics > Clear DTCs
Result
Proceed to NEXT Post-procedure1
- None
Result:
NEXT
See step 7
- Replace the telephone and GPS antenna (for Roof Side) with a known good one.
- CHECK FOR DTC
- Recheck for DTCs and check that no DTCs are output.
Body Electrical > Telematics > Trouble Codes
Result
Result Proceed to DTCs are not output A DTCs are output B
Result:
A
END (TELEPHONE AND GPS ANTENNA [for Roof Side] IS DEFECTIVE)
Result:
B
See step 8
- Recheck for DTCs and check that no DTCs are output.
- REPLACE DCM (TELEMATICS TRANSCEIVER)
- Replace the DCM (Telematics Transceiver).
Refer to REMOVAL [10/2022 - 10/2023] , or refer to REMOVAL [10/2023 - ]
NOTE:- The ignition switch must be off.
- Do not exchange the DCM (Telematics Transceiver) with one from another vehicle.
Result
Proceed to NEXT
Result:
NEXT
PERFORM DCM ACTIVATION. Refer to DCM ACTIVATION [10/2022 - ]
- Replace the DCM (Telematics Transceiver).