DTC B1577: GVIF Disconnected (from EMV/MM Integrated Device to RSE) [12/2017 - 10/2022]: Procedure
- CLEAR DTC
- Clear the DTCs.
Refer to DTC CHECK / CLEAR [12/2017 - 10/2022]
Body Electrical > Navigation System > Clear DTCs
Result
Proceed to NEXT
Result:
NEXT
See step 2
- Clear the DTCs.
- CHECK FOR DTC
- Check for DTCs.
Refer to DTC CHECK / CLEAR [12/2017 - 10/2022]
Body Electrical > Navigation System > Trouble Codes
OK
DTC B1577 are not output.
Result
Proceed to OK NG
Result:
OK
USE SIMULATION METHOD TO CHECK. Refer to HOW TO PROCEED WITH TROUBLESHOOTING [12/2017 - 09/2018] , or refer to HOW TO PROCEED WITH TROUBLESHOOTING [09/2018 - 10/2020] , or refer to HOW TO PROCEED WITH TROUBLESHOOTING [10/2020 - 11/2021] , or refer to HOW TO PROCEED WITH TROUBLESHOOTING [11/2021 - 10/2022]
Result:
NG
See step 3
- Check for DTCs.
- CHECK HARNESS AND CONNECTOR (GVIF CABLE)
- Disconnect the G140 radio receiver assembly connector.
*a GVIF Cable
(to Radio Receiver Assembly)*b GVIF Cable
(to Multi-display Controller Sub-assembly) - Disconnect the L160 multi-display controller sub-assembly connector.
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition G140-1 (GVO-) - L160-1 (GV1-) Always Below 1 Ω G140-2 (GVO+) - L160-2 (GV1+) Always Below 1 Ω G140-3 (GVG2) - L160-3 (GVG1) Always Below 1 Ω G140-1 (GVO-) - Body ground Always 10 kΩ or higher G140-2 (GVO+) - Body ground Always 10 kΩ or higher G140-3 (GVG2) - Body ground Always 10 kΩ or higher Result
Proceed to OK NG
Result:
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR (GVIF CABLE)
Result:
OK
See step 4
- Disconnect the G140 radio receiver assembly connector.
- REPLACE DISC PLAYER ASSEMBLY
- Replace the disc player assembly with a new or known good one.
Refer to REMOVAL [12/2017 - ]
Result
Proceed to NEXT
Result:
NEXT
See step 5
- Replace the disc player assembly with a new or known good one.
- CLEAR DTC
- Clear the DTCs.
Refer to DTC CHECK / CLEAR [12/2017 - 10/2022]
Body Electrical > Navigation System > Clear DTCs
Result
Proceed to NEXT
Result:
NEXT
See step 6
- Clear the DTCs.
- CHECK FOR DTC
- Check for DTCs.
Refer to DTC CHECK / CLEAR [12/2017 - 10/2022]
Body Electrical > Navigation System > Trouble Codes
OK
DTC B1577 are not output.
Result
Proceed to OK NG
Result:
OK
END (DISC PLAYER ASSEMBLY IS DEFECTIVE)
Result:
NG
REPLACE DISC PLAYER ASSEMBLY. Refer to REMOVAL [12/2017 - ]
- Check for DTCs.