LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2021 >> LS 500 Base, RWD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Entertainment Systems >> Audio / Video System - Service Information (2 Of 2) >> Active Noise Control Microphone >> Removal [10/2023 - ] >> Caution / Notice / Hint

Caution / Notice / Hint

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the active noise control microphone removal/installation are shown below.

NECESSARY PROCEDURES AFTER PARTS REMOVED/INSTALLED/REPLACED

Replacement Part or Procedure Necessary Procedures Effect/Inoperative Function When Necessary Procedures are not Performed Link
Disconnect cable from negative (-) battery terminal Operate the multiplex network master switch assembly (retractable outer mirror switch) to extend and retract the outer rear view mirror assembly Parking support brake system Refer to INITIALIZATION [10/2023 - ]
Initialize rear door sunshade system Rear door sunshade system Refer to INITIALIZATION [12/2017 - ]
Front seat assembly RH (Only for removal and installation) Zero point calibration (Occupant classification system)
  • Occupant classification system
  • Passenger airbag ON/OFF indicator
  • Airbag system (Front passenger side)
  • Seat belt warning system (Front passenger)
Refer to INITIALIZATION [10/2023 - ]
Windshield glass* (Including removal and installation) Adjust forward recognition camera
  • Front camera system
  • Traffic jam assist system
  • Adaptive high beam system
  • Autumatic High Beam System
for Target Adjustment (One Time Recognition):
Refer to TARGET ADJUSTMENT (ONE TIME RECOGNITION) [10/2023 - ]
for Driving Adjustment:
Refer to DRIVING ADJUSTMENT [10/2023 - ]
for Camera Axis Adjustment Value Write:
Refer to CAMERA AXIS ADJUSTMENT VALUE WRITE [10/2023 - ]

*: New automatic transmission's compensation code.

HINT: