Caution / Notice / Hint
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the radio receiver assembly removal/installation are shown below.
NECESSARY PROCEDURE AFTER PARTS REMOVED/INSTALLED/REPLACED
| Replacement part or procedure | Necessary procedures | Effects/Inoperative when not performed | Link |
|---|---|---|---|
| Radio receiver assembly | Register Vehicle Information*1 | - | Refer to REGISTRATION [10/2022 - ] |
| Software update | |||
| After replacing the radio receiver assembly of vehicles subscribed to pay-type satellite radio broadcasts, radio ID registration is necessary.*2 | The SXM satellite radio cannot be used | - | |
| Re-install the eOwner's manual | The eOwner's manual cannot be used |
*1: w/ Mayday System
*2: w/ SXM System