DTC B1AD7-71: Ceiling Front Left Speaker Cable Actuator Stuck [10/2022 - ]: Procedure
- CHECK HARNESS AND CONNECTOR (STEREO COMPONENT AMPLIFIER ASSEMBLY - ROOF SPEAKER ASSEMBLY (FR LH))
Pre-procedure1
- Disconnect the L54 stereo component amplifier assembly connector.
- Disconnect the N21 roof speaker assembly (FR LH) connector.
Procedure1
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition L54-1 (ROL+) - N21-2 Always Below 1 Ω L54-5 (ROL-) - N21-1 Always Below 1 Ω Result
Proceed to OK NG Post-procedure1
- None
Result:
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
Result:
OK
See step 2
- INSPECT ROOF SPEAKER ASSEMBLY (FR LH)
Refer to REMOVAL [10/2022 - 10/2023] , or refer to REMOVAL [10/2023 - ]
Result
Proceed to OK NG Result:
NG
REPLACE ROOF SPEAKER ASSEMBLY (FR RH). Refer to REMOVAL [10/2022 - 10/2023] , or refer to REMOVAL [10/2023 - ]
Result:
OK
See step 3
- CLEAR DTC
Result:
NEXT
See step 4
- SPEAKER LINE ELECTRICITY CHECK
- In accordance with the display of the GTS, perform a speaker line electricity check.
Body Electrical > Navigation System > Utility
Tester Display Speaker Line Electricity Check Result
Proceed to NEXT
Result:
NEXT
See step 5
- In accordance with the display of the GTS, perform a speaker line electricity check.
- CHECK FOR DTC
- Check for DTCs and proceed to the following step.
Body Electrical > Navigation System > Trouble Codes
Result
Result Proceed to DTCs are not output A DTC B1AD7-71 is output B
Result:
A
END (ROOF SPEAKER ASSEMBLY [FR LH] IS DEFECTIVE)
Result:
B
REPLACE STEREO COMPONENT AMPLIFIER. Refer to REMOVAL [10/2022 - 10/2023] , or refer to REMOVAL [10/2023 - ]
- Check for DTCs and proceed to the following step.