Caution / Notice / Hint

NOTE:

When replacing the radio receiver assembly, always replace it with a new one.
If a radio receiver assembly which was installed to another vehicle is used, the following may occur:
- A communication malfunction DTC may be stored.
- The radio receiver assembly may not operate normally.
After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
Refer to PRECAUTION [12/2017 - 10/2020]
Inspect the fuses for circuits related to this system before performing the following procedure.

HINT:

B1323, B1324, B1325 and B1326 will not continue to output when clear DTC is performed even if the malfunction continues.
Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Navigation System.
Refer to PRECAUTION [12/2017 - 10/2022]