LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2021 >> LS 500 Base, RWD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Drivers Assistance Systems - ADAS >> Monitor System - Service Information (1 Of 2) >> CLEARANCE WARNING BUZZER (for Rear Side) >> Removal [10/2020 - 10/2022] >> Procedure

Removal [10/2020 - 10/2022]: Procedure

  1. PRECAUTION 
    WARNING:

    Be sure to read precaution thoroughly before servicing.

    Refer to PRECAUTION [10/2020 - 11/2021] , or refer to PRECAUTION [11/2021 - 10/2023]

    GTY824211Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    NOTE:

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal.

    Refer to PRECAUTION [10/2020 - 10/2023]

  2. REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 25

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    1. Refer to PROCEDURE - Step 4
      WARNING:
      • Wait at least 60 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
      • If the airbag deploys for any reason, it may cause a serious accident.
      GTY581108Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  4. REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY 
    1. for power seat:

      Refer to REMOVAL [10/2020 - 10/2022]

    2. for fixed seat type:

      Refer to REMOVAL [10/2020 - 10/2022]

  5. REMOVE NO. 2 CLEARANCE WARNING BUZZER 
    GTY815342Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. Using a clip remover, detach the clamp and remove the No. 2 clearance warning buzzer.
    2. Disconnect the connector.
scientia non olet · About LEMON Manuals