Caution / Notice / Hint

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the front ultrasonic sensor removal/installation are shown below.

NECESSARY PROCEDURE AFTER PARTS REMOVED/INSTALLED/REPLACED

Replaced Part or Performed Procedures	Necessary Procedures	Effect/Inoperative Function When Necessary Procedures are not Performed	Link
Ultrasonic sensor	Ultrasonic sensor detection angle Ultrasonic sensor detection angle registration	Parking support alert system Parking support brake system	Refer to CALIBRATION [12/2017 - 10/2020]
w/ Panoramic View Monitor System Front bumper assembly (Including removal and installation)	Front television camera view adjustment	Panoramic view monitor system	Refer to CALIBRATION [12/2017 - 10/2020]

HINT:

Use the same procedure for the RH and LH side.
The following procedure is for the LH side.