Caution / Notice / Hint

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during rear door lock with motor assembly removal/installation are shown below.

Replaced Part or Performed Procedures	Necessary Procedures	Effect/Inoperative Function When Necessary Procedures are not Performed	Link
Disconnect cable from negative (-) battery terminal	Operate the multiplex network master switch assembly (retractable outer mirror switch) to extend and retract the outer rear view mirror assembly	Parking support brake system	Refer to INITIALIZATION [10/2023 - ]
Disconnect cable from negative (-) battery terminal	Initialize rear door sunshade system	Rear door sunshade system	Refer to INITIALIZATION [12/2017 - ]
Rear multiplex network door ECU LH Rear multiplex network door ECU RH Rear multiplex network door ECU LH or rear multiplex network door ECU RH is the connectors are disconnected	Initialize rear door sunshade system	The rear door sunshade system does not operate	Refer to INITIALIZATION [12/2017 - ]
Power window regulator motor assembly LH Power window regulator motor assembly RH Rear door window regulator assembly LH Rear door window regulator assembly RH Rear door glass sub-assembly LH Rear door glass sub-assembly RH Rear door glass run LH Rear door glass run RH Rear door No. 3 glass run LH Rear door No. 3 glass run RH	Initialize power window control system	Auto up and down function Jam protection function Catch protection function Remote control function Key-linked function Wireless transmitter-linked function Key-off operation function Window open warning function	Refer to REGISTRATION [10/2023 - ]

HINT:

When the cable is disconnected/reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed	Necessary Procedures	Link
Lighting system (EXT) Cornering lights	Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 seconds or more.	Refer to INITIALIZATION [10/2023 - ]
Front camera system
AFS (Front-lighting adaptive system)

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed	Necessary Procedures	Link
Power trunk lid system	Fully close the luggage compartment door by hand. HINT: Initialization is not necessary if the above procedures are performed while the luggage compartment door is closed.	Refer to INITIALIZATION [10/2023 - ]

Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
When removing the rear door glass sub-assembly LH, move the rear door glass sub-assembly LH to the lowest position before disconnecting the battery negative (-) terminal.