Removal [12/2017 - 09/2018]: Procedure
- PRECAUTION WARNING:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.
Refer to PRECAUTION [12/2017 - 10/2020]
NOTE:After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
Refer to PRECAUTION [12/2017 - 10/2020]
- REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY
Refer to PROCEDURE - Step 24
- DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Refer to PROCEDURE - Step 3
WARNING:- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
Refer to PRECAUTION [12/2017 - 10/2020]
- If the airbag deploys for any reason, it may cause a serious accident.
NOTE:When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Refer to INITIALIZATION [12/2017 - 09/2018]
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
- REMOVE INSTRUMENT PANEL SAFETY PAD ASSEMBLY
Refer to REMOVAL [12/2017 - 09/2018]
- REMOVE NO. 5 HEATER TO REGISTER DUCT
Refer to PROCEDURE - Step 1
- REMOVE NO. 2 SIDE DEFROSTER NOZZLE DUCT
Refer to PROCEDURE - Step 2
- REMOVE DEFROSTER NOZZLE ASSEMBLY
Refer to PROCEDURE - Step 4
- REMOVE NAVIGATION ANTENNA ASSEMBLY WITH BRACKET
- REMOVE NAVIGATION ANTENNA ASSEMBLY
- Detach the claw.
- Disconnect the connector and remove the antenna cord sub-assembly.
- Detach the claw.
Remove in this Direction - While moving the navigation antenna assembly in the direction indicated in the illustration, detach the guide and remove the navigation antenna assembly from the navigation antenna bracket.
- Detach the claw.
- REMOVE NAVIGATION ANTENNA BRACKET