Removal [10/2020 - 10/2022]: Procedure
- PRECAUTION WARNING:
Be sure to read precaution thoroughly before servicing.
Refer to PRECAUTION [10/2020 - 11/2021] , or refer to PRECAUTION [11/2021 - 10/2023]
NOTE:After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal.
- REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY
Refer to PROCEDURE - Step 25
- DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Refer to PROCEDURE - Step 4
- REMOVE INSTRUMENT PANEL SAFETY PAD ASSEMBLY
Refer to REMOVAL [10/2020 - 10/2022]
- REMOVE NO. 5 HEATER TO REGISTER DUCT
Refer to PROCEDURE - Step 1
- REMOVE NO. 2 SIDE DEFROSTER NOZZLE DUCT
Refer to PROCEDURE - Step 2
- REMOVE DEFROSTER NOZZLE ASSEMBLY
Refer to PROCEDURE - Step 4
- REMOVE NAVIGATION ANTENNA ASSEMBLY WITH BRACKET
- REMOVE NAVIGATION ANTENNA ASSEMBLY
- Detach the claw.
- Disconnect the connector and remove the antenna cord sub-assembly.
- Detach the claw.
Remove in this Direction - While moving the navigation antenna assembly in the direction indicated in the illustration, detach the guide and remove the navigation antenna assembly from the navigation antenna bracket.
- Detach the claw.
- REMOVE NAVIGATION ANTENNA BRACKET