Steering Pad Switch Circuit [01/2017 - ]: Procedure

1. Remove the steering pad switch assembly.

   Refer to REMOVAL [01/2017 - 05/2023] , or refer to REMOVAL [05/2023 - ]

2. Inspect the steering pad switch assembly.

   Refer to INSPECTION [01/2017 - ]

   Result

   Proceed to
   OK
   NG

Result: 

NG 

REPLACE STEERING PAD SWITCH ASSEMBLY. Refer to  REMOVAL [01/2017 - 05/2023]  , or refer to  REMOVAL [05/2023 - ] 

Result: 

OK 

See step  2

1. Remove the spiral cable with sensor sub-assembly.

   Refer to REMOVAL [01/2017 - 05/2023] , or refer to REMOVAL [05/2023 - ]

2. Inspect the spiral cable with sensor sub-assembly.

   Refer to INSPECTION [01/2017 - ]

   Result

   Proceed to
   OK
   NG

Result: 

NG 

REPLACE SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY. Refer to  REMOVAL [01/2017 - 05/2023]  , or refer to  REMOVAL [05/2023 - ] 

Result: 

OK 

See step  3

1. Disconnect the P25 combination meter assembly connector.
2. Disconnect the z2 spiral cable with sensor sub-assembly connector.
3. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   P25-2 (MSM+) - P19-11 (+DP)	Always	Below 1 Ω
   P25-1 (MSSL) - P19-4 (EAU)	Always	Below 1 Ω
   P25-3 (MSTI) - P19-10 (+DP2)	Always	Below 1 Ω
   P25-2 (MSM+) - Body ground	Always	Below 1 Ω
   P25-2 (MSM+) - Other terminals and body ground	Always	10 kΩ or higher
   P25-1 (MSSL) - Other terminals and body ground	Always	10 kΩ or higher
   P25-3 (MSTI) - Other terminals and body ground	Always	10 kΩ or higher

   Result

   Proceed to
   OK
   NG

Result: 

OK 

REPLACE COMBINATION METER ASSEMBLY. Refer to  REMOVAL [01/2017 - ] 

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR