Caution / Notice / Hint
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the clock assembly removal/installation are shown below.
NECESSARY PROCEDURES AFTER PARTS REMOVED / INSTALLED / REPLACED
| Replacement Part or Procedure | Necessary Procedures | Effects / Inoperative when not Performed | Link |
|---|---|---|---|
| Disconnect cable from negative auxiliary battery terminal | Memorize steering angle neutral point | Lane-keeping assist system | Refer to INITIALIZATION [01/2017 - 05/2023] |
| Pre-collision system | |||
| Parking assist monitor system | Refer to INITIALIZATION [01/2017 - 05/2023] | ||
| Steering sensor zero point calibration | Variable gear ratio steering system | Refer to INITIALIZATION [01/2017 - ] |
WARNING:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.
Refer to PRECAUTION [01/2017 - 04/2020] , or refer to PRECAUTION [04/2020 - 05/2023]