Installation [03/2017 - 05/2023]: Procedure

1. Insert the rear suspension toe adjust cam sub-assembly from the front of the vehicle. Then temporarily tighten the rear No. 2 suspension toe adjust plate and toe control link sub-assembly LH with the nut.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a

   Matchmark

   NOTE:

   Align the matchmarks on the rear No. 2 suspension toe adjust plate and rear suspension member sub-assembly.

2. Temporarily tighten the toe control link sub-assembly LH with a new nut.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Install the skid control sensor wire LH to the toe control link sub-assembly LH with the bolt.

   Torque: 8.5 N.m (87 kgf/cm, 75 in.lbf) 

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

See step  7 [03/2017 - 04/2020], or see step  7 [04/2020 - 05/2023]

1. Fully tighten the nut (rear suspension member sub-assembly side).

   Torque: 78 N.m (795 kgf/cm, 58 ft.lbf) 

2. Fully tighten the nut (rear axle carrier sub-assembly LH side).

   Torque: 118 N.m (1203 kgf/cm, 87 ft.lbf) 

Refer to INSTALLATION [03/2017 - 05/2023]

Refer to ADJUSTMENT [03/2017 - 04/2020] , or refer to ADJUSTMENT [04/2020 - 05/2023]

Refer to ADJUSTMENT [03/2017 - ]

Refer to CALIBRATION [03/2017 - 05/2023]