Caution / Notice / Hint
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the rear upper arm removal/installation are shown below.
Necessary Procedure After Parts Removed/Installed/Replaced
| Replacement Part or Procedure | Necessary Procedures | Effects/Inoperative when not Performed | Link |
|---|---|---|---|
| Suspension, tires, etc | Parking assist ECU initialization | Panoramic view monitor system | Refer to CALIBRATION [05/2023 - ] |
| Rear steering link assembly or rear suspension have been removed/installed, replaced, or adjusted |
|
Steering wheel off-center | Refer to CALIBRATION [09/2018 - ] |
HINT:
- Use the same procedure for the RH and LH sides.
- The procedure listed below is for the LH side.