Caution / Notice / Hint
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the front shock absorber removal/installation are shown below.
Necessary Procedure After Parts Removed/Installed/Replaced
| Replacement Part or Procedure | Necessary Procedures | Effects/Inoperative when not Performed | Link |
|---|---|---|---|
| Parking brake with bracket actuator assembly (Including removal and installation) |
|
Electric parking brake system | Refer to INITIALIZATION [03/2017 - 09/2018] , or refer to INITIALIZATION [09/2018 - ] |
|
Parking brake bedding | Electric parking brake system | Refer to INITIALIZATION [03/2017 - 09/2018] , or refer to INITIALIZATION [09/2018 - ] |
| Suspension, tires, etc | Television camera assembly optical axis (Back camera position setting) | Parking assist monitor system | Refer to CALIBRATION [03/2017 - 05/2023] |
| Rear steering link assembly or rear suspension have been removed/installed, replaced, or adjusted |
|
Steering wheel off-center | Refer to CALIBRATION [03/2017 - 09/2018] , or refer to CALIBRATION [09/2018 - ] |
| Disconnect cable from negative battery terminal | Memorize steering angle neutral point | Lane-keeping assist system | Refer to INITIALIZATION [03/2017 - 05/2023] |
| Pre-collision system | |||
| Parking assist monitor system | Refer to INITIALIZATION [03/2017 - 05/2023] | ||
| Steering Sensor Initialization | Variable gear ratio steering system | Refer to INITIALIZATION [03/2017 - ] |
HINT:
- Use the same procedure for the RH and LH sides.
- The procedure listed below is for the LH side.