DTC C13A6/42: Open or Short in Circuit of Motor [03/2017 - 09/2018]: Procedure

1. Turn the engine switch off.
2. Disconnect the X66 parking brake ECU assembly connector.
3. Disconnect the X68 parking brake with bracket actuator assembly connector.
4. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   X66-1 (M-) - X68-7 (M-)	Always	Below 1 Ω
   X66-1 (M-) or X68-7 (M-) - Body ground	Always	10 kΩ or higher
   X66-2 (M+) - X68-8 (M+)	Always	Below 1 Ω
   X66-2 (M+) or X68-8 (M+) - Body ground	Always	10 kΩ or higher

   Result

   Proceed to
   OK
   NG

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR 

Result: 

OK 

See step  2

1. Turn the engine switch off.
2. Disconnect the X68 parking brake with bracket actuator assembly connector.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Component without harness connected (Parking Brake with Bracket Actuator Assembly)

3. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   7 (M-) - 8 (M+)	Always	Below 4 Ω
   7 (M-) - Body ground	Always	10 kΩ or higher
   8 (M+) - Body ground	Always	10 kΩ or higher

   Result

   Proceed to
   OK
   NG

Result: 

OK 

REPLACE PARKING BRAKE ECU ASSEMBLY. Refer to  REMOVAL [03/2017 - 05/2023] 

Result: 

NG 

REPLACE PARKING BRAKE WITH BRACKET ACTUATOR ASSEMBLY. Refer to  REMOVAL [03/2017 - 05/2023]