LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2021 >> LC 500 2D Coupe >> Repair and Diagnosis >> Brakes >> Parking Brake System >> Electric Parking Brake System - Diagnostic Codes & Symptom Tests (Coupe) >> Electric Parking Brake System >> DTC C13A3: Open or Short Circuit in Lock Switch Circuit; DTC C13AB: Lock Switch Circuit Comparison [09/2018 - ] >> Procedure

DTC C13A3: Open or Short Circuit in Lock Switch Circuit; DTC C13AB: Lock Switch Circuit Comparison [09/2018 - ]: Procedure

  1. INSPECT ELECTRIC PARKING BRAKE SWITCH ASSEMBLY 
    1. Inspect the electric parking brake switch assembly.

      Refer to INSPECTION [03/2017 - ]

      Result

      Proceed to
      OK
      NG

    Result: 

    NG 

    REPLACE ELECTRIC PARKING BRAKE SWITCH ASSEMBLY. Refer to  REMOVAL [03/2017 - ] 

    Result: 

    OK 

    See step  2

  2. CHECK HARNESS AND CONNECTOR (PARKING BRAKE ECU ASSEMBLY - ELECTRIC PARKING BRAKE SWITCH ASSEMBLY) 
    1. Turn the engine switch off.
    2. Disconnect the P36 electric parking brake switch assembly connector.
    3. Disconnect the X67 parking brake ECU assembly connector.
    4. Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection Condition Specified Condition
      X67-12 (LCK1) - P36-1 (LOK1) Always Below 5 Ω
      X67-15 (LCK2) - P36-2 (LOK2) Always Below 5 Ω
      X67-12 (LCK1) or P36-1 (LOK1) - Body ground Always 10 kΩ or higher
      X67-15 (LCK2) or P36-2 (LOK2) - Body ground Always 10 kΩ or higher
      P36-14 (GND1) - Body ground Always Below 5 Ω

      Result

      Proceed to
      OK
      NG

    Result: 

    NG 

    REPAIR OR REPLACE HARNESS OR CONNECTOR 

    Result: 

    OK 

    See step  3

  3. CHECK DTC 
    1. Clear the DTCs.

      Refer to DTC CHECK / CLEAR [09/2018 - ]

      Chassis > Electric Parking Brake > Clear DTCs 

    2. Turn the engine switch off.
    3. Turn the engine switch on (IG).
    4. Perform a lock operation with the electric parking brake switch assembly.

      HINT: 

      When the electric parking brake switch assembly is pushed and held for 1 second or more without being pushed fully to the lock side, one of the 2 linked contacts may turn on while the other one turns off causing this DTC to be stored.

    5. Check for DTCs.

      Refer to DTC CHECK / CLEAR [09/2018 - ]

      Chassis > Electric Parking Brake > Trouble Codes 

      Result

      Result Proceed to
      DTC is output A
      DTC is not output B

    Result: 

    REPLACE PARKING BRAKE ECU ASSEMBLY. Refer to  REMOVAL [03/2017 - 05/2023]  , or refer to  REMOVAL [05/2023 - ] 

    Result: 

    USE SIMULATION METHOD TO CHECK. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [03/2017 - 04/2020]  , or refer to  HOW TO PROCEED WITH TROUBLESHOOTING [04/2020 - 05/2023]  , or refer to  HOW TO PROCEED WITH TROUBLESHOOTING [05/2023 - ]