LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2021 >> LC 500 2D Coupe >> Repair and Diagnosis >> Body & Frame >> Seats >> Seats - Service Information (Coupe) (2 Of 2) >> Limit Switch >> Installation [05/2023 - ] >> Procedure

Installation [05/2023 - ]: Procedure

  1. INSTALL LH SEAT FRONT INNER SEATBACK EDGE PROTECTOR (LIMIT SWITCH) (for Inner Side) 
    1. Slide in the installation direction shown in the illustration to attach the guides.
      GTY779510Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Screw
      Connector
      Install in this Direction
    2. Install the limit switch assembly with the screw.
    3. Connect the connector.
  2. INSTALL SEAT RECLINING ADJUSTER INSIDE COVER LH 

    Refer to PROCEDURE - Step 35

  3. INSTALL SEPARATE TYPE FRONT SEATBACK COVER WITH PAD (for Standard Seat Type) 

    Refer to PROCEDURE - Step 38

  4. INSTALL FRONT SEATBACK PAD WITH COVER LH (for Sports Seat Type) 

    Refer to PROCEDURE - Step 39

  5. INSTALL FRONT UPPER SEATBACK COVER SUB-ASSEMBLY LH (for Standard Seat Type) 

    Refer to PROCEDURE - Step 40

  6. INSTALL FRONT SEAT HEADREST SUPPORT (for Standard Seat Type) 

    Refer to PROCEDURE - Step 41

  7. INSTALL FRONT SEAT HEADREST SUPPORT (for Sports Seat Type) 

    Refer to PROCEDURE - Step 42

  8. INSTALL FRONT SEATBACK SUB-ASSEMBLY LH (for Standard Seat Type) 

    Refer to PROCEDURE - Step 43

  9. INSTALL RECLINING REMOTE CONTROL LEVER SUB-ASSEMBLY LH 

    Refer to PROCEDURE - Step 45

  10. INSTALL SEAT ADJUSTER COVER CAP LH 

    Refer to PROCEDURE - Step 46

  11. INSTALL SEPARATE TYPE FRONT SEATBACK ASSEMBLY 

    Refer to PROCEDURE - Step 47

  12. INSTALL FRONT INNER SEAT CUSHION SHIELD LH 

    Refer to PROCEDURE - Step 49

  13. INSTALL LH SEAT FRONT OUTER SEATBACK EDGE PROTECTOR (LIMIT SWITCH) (for Outer Side) 
    1. Slide in the installation direction shown in the illustration to attach the guides.
      GTY832339Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Screw
      Connector
      Install in this Direction
    2. Install the limit switch assembly with the 2 screws.
    3. Connect the connector.
  14. INSTALL FRONT SEAT CUSHION SHIELD LH 

    Refer to PROCEDURE - Step 56

  15. INSTALL FRONT SEAT ASSEMBLY LH 

    Refer to INSTALLATION [05/2023 - ]

  16. INITIALIZATION OF SEAT ECU 

    Refer to PROCEDURE - Step 2

  17. PERFORM ZERO POINT CALIBRATION AND SENSITIVITY CHECK (for Front Passenger Seat) 

    Refer to INITIALIZATION [03/2017 - ]

  18. INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL 

    HINT: 

    When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.

    Refer to AUTOMATIC LEARNING CHART [05/2023 - ]

scientia non olet · About LEMON Manuals